Repair / Calibration

Most premium tools and some commercial tools can be economically serviced and repaired. Our tooling Service Centre holds spares for all commonly used tools along with the specialist equipment and skills required to re-calibrate after repair.

Tyco Electronics recommends that for hand tools a calibration check is carried out every 6 months or every 5,000 crimp cycles, whichever the sooner.
We calibrate and provide certificates for the following Tyco Electronics / AMP equipment:

• Premium tools complete
• Interchangeable dies (independent of the optional equipment they are used in)
• Any equipment that has measurable parameters.

Tyco Electronics Langen
GATD Workshop
AMPerestr. 7-11
63225 Langen
Germany
Tel: +49 6103 709 3320
Fax: +49 6103 709 3076
Contact us by email here
Only this Tyco Electronics approved Service Centre has the necessary access to engineering drawings and specialised equipment required for our repair and calibration processes.

Tyco Electronics uses crimp height as the primary measure of crimp quality integrity, and does not recognise pull-off values alone as a measure. If you would like more information on this subject, why not get in touch with your Country Contact who will be happy to arrange a visit to present explanatory information.